Difficulty
Moderate
Steps
7
Time Required
15 minutes
Sections
1
- Battery
- 7 steps
Flags
0
BackMotorola Atrix HD
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The battery may be removed with or without removing the back chassis. However you choose to remove it, take extra care when removing the ribbon cable attached to the motherboard, it is very thin and easily damaged.
What you need
Step 1
Battery
- Before disassembling the phone, remove the SIM card and the MICRO-SD card, if equipped.
- Begin taking apart the device by prying apart the back cover from the assembly using the plastic opening tool.
- Continue working around the edge of the phone using the plastic opening tool.
- When all the edges have been lifted apart, use your hands or plastic opening tool to peel the back plate from the battery. There are small adhesive strips between the back cover and the battery, so take care not to crack the back cover while prying open.
Before disassembling the phone, remove the SIM card and the MICRO-SD card, if equipped.
Begin taking apart the device by prying apart the back cover from the assembly using the plastic opening tool.
Continue working around the edge of the phone using the plastic opening tool.
When all the edges have been lifted apart, use your hands or plastic opening tool to peel the back plate from the battery. There are small adhesive strips between the back cover and the battery, so take care not to crack the back cover while prying open.
1024
Step 2
- The adhesive strips are shown in the orange boxes. Be sure not to use too much force to pull off the back cover, or you may risk snapping the back cover.
The adhesive strips are shown in the orange boxes. Be sure not to use too much force to pull off the back cover, or you may risk snapping the back cover.
Step 3
- Remove the red rubber screw cover with a pair of tweezers
Remove the red rubber screw cover with a pair of tweezers
Step 4
- Use the T-5 Torx bit to remove the two silver 3.3 mm screws with integrated washers.
Use the T-5 Torx bit to remove the two silver 3.3 mm screws with integrated washers.
Step 5
- Lift the battery leads to the upward position. The ribbon cable is very thin, be gentle.
Lift the battery leads to the upward position. The ribbon cable is very thin, be gentle.
Step 6
- Use the plastic opening tool around the edges to loosen the battery.
- Once the battery is loose, carefully lift from the bottom edge and remove the battery.
Use the plastic opening tool around the edges to loosen the battery.
Once the battery is loose, carefully lift from the bottom edge and remove the battery.
Step 7
- The battery may now be removed.
The battery may now be removed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Bradley Hinckley
Member since: 10/28/2015
552 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team 1-8, Miles Fall 2015
Member of UMass Dartmouth, Team 1-8, Miles Fall 2015
UMASSD-MILES-F15S1G8
3 Members
10 Guides authored
jvandeputte - Feb 24, 2017
Reply
How do you calibrate it then? Lights up green dot, charges, won’t work! Multi tester shows full power.