Difficulty
Moderate
Steps
7
Time Required
1 hour
Sections
1
- The Motor and Cord
- 7 steps
Flags
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackNinja Master Prep QB900B
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
The Motor and Cord
- Remove the highlighted screws shown with a Phillips #2 Screwdriver.
Remove the highlighted screws shown with a Phillips #2 Screwdriver.
1024
Step 2
- Remove the motor from the motor mounting plate. Pull the motor and cord to the side.
Remove the motor from the motor mounting plate. Pull the motor and cord to the side.
Step 3
- Use pliers to grip the crimp.
Use pliers to grip the crimp.
Step 4
- Open the crimp by pressing it opposite to how the crimp was pressed. Repeat for second crimp.
Open the crimp by pressing it opposite to how the crimp was pressed. Repeat for second crimp.
Step 5
- Remove the crimps from the wires by pulling them off.
Remove the crimps from the wires by pulling them off.
Step 6
- Untwist the brown and the silver wire by gripping the tip and unwinding them. Do the same for the second wire.
Untwist the brown and the silver wire by gripping the tip and unwinding them. Do the same for the second wire.
Step 7
- Separate the cord and motor.
- Now, depending on whether the cord or the motor was broken, head to the device page to order a new one.
Separate the cord and motor.
Now, depending on whether the cord or the motor was broken, head to the device page to order a new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Kamal Taha
Member since: 08/27/2015
679 Reputation
5 Guides authored
Badges:
16
+13 more badges
Team
USF Tampa, Team 1-3, Sullivan Fall 2015
Member of USF Tampa, Team 1-3, Sullivan Fall 2015
USFT-SULLIVAN-F15S1G3
3 Members
5 Guides authored