Difficulty
Moderate
Steps
10
Time Required
15 - 25 minutes
Sections
1
- Fuse
- 10 steps
Flags
0
BackMontiss Air Bubble Massage Machine blown fuse replacement
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Fuse
- Place the product in front of you
Place the product in front of you
1024
Step 2
- Grab the tube, twist it and take it out.
Grab the tube, twist it and take it out.
Step 3
- Turn the product upside down, you will see five holes, in which the screws are located.
Turn the product upside down, you will see five holes, in which the screws are located.
Step 4
- Use a Phillips screwdriver to loosen the screws, then turn the product right side up to get the screws out of the casing.
Use a Phillips screwdriver to loosen the screws, then turn the product right side up to get the screws out of the casing.
Step 5
- Place the product on its feet and place the upper part of the casing next to the bottom part.
Place the product on its feet and place the upper part of the casing next to the bottom part.
Step 6
- An electronic wire is connecting the two PCB’s. Take off the PCB in the lower part of the case by gently pulling the plastic housing, the connection will slowly loosen.
An electronic wire is connecting the two PCB’s. Take off the PCB in the lower part of the case by gently pulling the plastic housing, the connection will slowly loosen.
Step 7
- Take the PCB out of the case. Here you can see the fuse you want to replace
Take the PCB out of the case. Here you can see the fuse you want to replace
Step 8
- Desolder the two spots connecting the fuse to the PCB. If you have never done this before, use this guide from iFixIt.
Desolder the two spots connecting the fuse to the PCB. If you have never done this before, use this guide from iFixIt.
Step 9
- Take out the fuse with some pliers, since it will be hot because of the soldering.
Take out the fuse with some pliers, since it will be hot because of the soldering.
Step 10
- Put in a new fuse and solder it back in place. Now you can reassemble the product.
Put in a new fuse and solder it back in place. Now you can reassemble the product.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 5 other contributors
Lisa Hoogeveen
Member since: 03/08/2017
101 Reputation
1 Guide authored
Badges:
2
Team
Delft University of Technology, Team S1-G22, Flipsen Spring 2017
Member of Delft University of Technology, Team S1-G22, Flipsen Spring 2017
TUD-FLIPSEN-S17S1G22
3 Members
1 Guide authored
