Monster Soundstage S1 Mini Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

1

• Speaker
• 6 steps

Flags

2

Missing Prerequisites

This guide is missing information on how to start the process. Make a prerequisite guide!

Better Introduction

Improve this guide by completing or revising its introduction.

• BackMonster SoundStage S1 Mini

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Speaker               

• Remove the speaker wires from the motherboard by pinching the plastic tab at the end of the cable and pulling towards you.

Remove the speaker wires from the motherboard by pinching the plastic tab at the end of the cable and pulling towards you.

1024

Step 2

• Unscrew 1.2 cm Torx security screw, holding the silver circle connector, to disconnect the wire from the speakerboard to the motherboard

Unscrew 1.2 cm Torx security screw, holding the silver circle connector, to disconnect the wire from the speakerboard to the motherboard

Step 3

• Remove the black putty from the speaker wires at both ends of the speaker board.

Remove the black putty from the speaker wires at both ends of the speaker board.

Step 4

• Solder the black plastic encasing the red and black wires.

Solder the black plastic encasing the red and black wires.

Step 5

• Remove both the black and red wires with pliers
• Pliers may stick to speaker because it is magnetic.

Remove both the black and red wires with pliers

Pliers may stick to speaker because it is magnetic.

Step 6

• Tuck wires through the hole where the speaker is located, then gently push the speaker out.
• The 1.2 cm Torx security screws that stayed in place near the speaker will now fall out.
• To remove the other speaker repeat steps 3-6

Tuck wires through the hole where the speaker is located, then gently push the speaker out.

The 1.2 cm Torx security screws that stayed in place near the speaker will now fall out.

To remove the other speaker repeat steps 3-6

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 3 other contributors 

                    Heather Carrillo                     

Member since: 09/12/2016

412 Reputation

                                      2 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       CSU Fullerton, Team 2-6, Bruce Fall 2016                        

                                                  Member of CSU Fullerton, Team 2-6, Bruce Fall 2016 



                    CSUF-BRUCE-F16S2G6                     


                                            4 Members                     


                                            7 Guides authored