Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
1
- Speaker Wiring
- 6 steps
Flags
0
BackModal MD-SPBT01
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Speaker Wiring
- Use the plastic opening tool to pull the metal cover off the top of the speaker.
Use the plastic opening tool to pull the metal cover off the top of the speaker.
1024
Step 2
- Remove the four screws that are inside the holes on the top of the speaker.
- Use a Phillips 00 screwdriver to remove the 10mm screws.
Remove the four screws that are inside the holes on the top of the speaker.
Use a Phillips 00 screwdriver to remove the 10mm screws.
Step 3
- Pull the top piece of the speaker off to allow access to the interior.
Pull the top piece of the speaker off to allow access to the interior.
Step 4
- Locate the speaker wire connection and remove the wiring.
- Locate the LED lighting wire and remove that as well.
Locate the speaker wire connection and remove the wiring.
Locate the LED lighting wire and remove that as well.
Step 5
- Once you disconnect the wires, you can remove the speaker.
Once you disconnect the wires, you can remove the speaker.
Step 6
- Remove the positive and negative connections for the wiring to fully disconnect the wire.
- Now that you have removed the defective wiring, you can install a new one.
Remove the positive and negative connections for the wiring to fully disconnect the wire.
Now that you have removed the defective wiring, you can install a new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Nathan Hall
Member since: 10/13/2015
258 Reputation
2 Guides authored
Badges:
12
+9 more badges
Team
Sam Houston State, Team 2-4, Blackburne Fall 2015
Member of Sam Houston State, Team 2-4, Blackburne Fall 2015
SHSU-BLACKBURNE-F15S2G4
3 Members
4 Guides authored
