Difficulty

Moderate

Steps

11

Time Required

Suggest a time??

Sections

4

  • Blade Cover
  • 5 steps
  • Blade
  • 3 steps
  • Cutting Head
  • 1 step
  • Bottom Cover
  • 2 steps

Flags

0

  • BackMK Diamond Wet Saw MK660 (2010)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Blade Cover
  • Before you begin, make sure to power off and unplug the device from the outlet.
  • If the clear water pump hose is connected, remove it now.
  • Loosen the plastic knob holding the saw’s cutting head in place.
  • Lower the cutting head while keeping it steady.

Before you begin, make sure to power off and unplug the device from the outlet.

If the clear water pump hose is connected, remove it now.

Loosen the plastic knob holding the saw’s cutting head in place.

Lower the cutting head while keeping it steady.

1024

Step 2

  • Unscrew the knob.
  • Remove it from the cutting head.

Unscrew the knob.

Remove it from the cutting head.

Step 3

  • Loosen the plastic knob holding the blade cover in place.

Loosen the plastic knob holding the blade cover in place.

Step 4

  • Loosen the wing nut on the blade cover pivot shaft.
  • Remove the wing nut and accompanying washer.

Loosen the wing nut on the blade cover pivot shaft.

Remove the wing nut and accompanying washer.

Step 5

  • Pivot the blade cover up and pull it off the shaft.

Pivot the blade cover up and pull it off the shaft.

Step 6

              Blade
  • Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade.
  • Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.

Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade.

Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.

Step 7

  • Remove the hex nut.
  • Remove the outer flange.

Remove the hex nut.

Remove the outer flange.

Step 8

  • Remove the cutting blade.
  • The blade can be sharp, so handle with care.

Remove the cutting blade.

The blade can be sharp, so handle with care.

Step 9

              Cutting Head
  • Pull the entire cutting head straight off the shaft holding it in place.

Pull the entire cutting head straight off the shaft holding it in place.

Step 10

              Bottom Cover
  • Remove the eight Phillips #2 screws on the underside of the cutting head.

Remove the eight Phillips #2 screws on the underside of the cutting head.

Step 11

  • Remove the bottom cover.

Remove the bottom cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Carsten Frauenheim

Member since: 03/10/2020

81,710 Reputation

                                      330 Guides authored                  



                       Badges:
                       38







                                                        +35 more badges

Team

                       iFixit                        

                                                  Member of iFixit 



                    Community                     


                                            141 Members                     


                                            15,769 Guides authored