Difficulty
Moderate
Steps
8
Time Required
Suggest a time??
Sections
2
- Blade Cover
- 5 steps
- Blade
- 3 steps
Flags
0
BackMK Diamond Wet Saw MK660 (2010)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Blade Cover
- Before you begin, make sure to power off and unplug the device from the outlet.
- If the clear water pump hose is connected, remove it now.
- Loosen the plastic knob holding the saw’s cutting head in place.
- Lower the cutting head while keeping it steady.
Before you begin, make sure to power off and unplug the device from the outlet.
If the clear water pump hose is connected, remove it now.
Loosen the plastic knob holding the saw’s cutting head in place.
Lower the cutting head while keeping it steady.
1024
Step 2
- Unscrew the knob.
- Remove it from the cutting head.
Unscrew the knob.
Remove it from the cutting head.
Step 3
- Loosen the plastic knob holding the blade cover in place.
Loosen the plastic knob holding the blade cover in place.
Step 4
- Loosen the wing nut on the blade cover pivot shaft.
- Remove the wing nut and accompanying washer.
Loosen the wing nut on the blade cover pivot shaft.
Remove the wing nut and accompanying washer.
Step 5
- Pivot the blade cover up and pull it off the shaft.
Pivot the blade cover up and pull it off the shaft.
Step 6
Blade
- Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade.
- Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.
Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade.
Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.
Step 7
- Remove the hex nut.
- Remove the outer flange.
Remove the hex nut.
Remove the outer flange.
Step 8
- Remove the cutting blade.
- The blade can be sharp, so handle with care.
Remove the cutting blade.
The blade can be sharp, so handle with care.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Carsten Frauenheim
Member since: 03/10/2020
81,710 Reputation
330 Guides authored
Badges:
38
+35 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,769 Guides authored