Difficulty
Moderate
Steps
4
Time Required
25 minutes
Sections
1
- Speaker
- 4 steps
Flags
0
BackMJS T2702
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Speaker
- Separate the back of the device from the face by inserting the flat end of the nylon spudger into the corner of the device to safely pry it open.
Separate the back of the device from the face by inserting the flat end of the nylon spudger into the corner of the device to safely pry it open.
1024
Step 2
- Remove the 4.1 mm screws connecting the speaker to the device by using the Phillips Head J #000.
Remove the 4.1 mm screws connecting the speaker to the device by using the Phillips Head J #000.
Step 3
- Remove the plastic cover from the speaker by pulling it off gently with your hands.
Remove the plastic cover from the speaker by pulling it off gently with your hands.
Step 4
- Remove wires from the device with a solder iron. Use the soldering technique guide for helpful tips!
Remove wires from the device with a solder iron. Use the soldering technique guide for helpful tips!
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Katalina Benecke
Member since: 10/10/2016
364 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
Texas Tech, Team 1-13, Bennett Fall 2016
Member of Texas Tech, Team 1-13, Bennett Fall 2016
TTU-BENNETT-F16S1G13
5 Members
6 Guides authored