Difficulty
Moderate
Steps
6
Time Required
10 minutes
Sections
2
- Battery
- 3 steps
- Screen
- 3 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackMJS T2702
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Battery
- Separate the back of the device from the face by inserting the flat end of the nylon spudger into the corner of the device to safely pry it open.
Separate the back of the device from the face by inserting the flat end of the nylon spudger into the corner of the device to safely pry it open.
1024
Step 2
- Use the nylon spudger to gently pry out the battery.
Use the nylon spudger to gently pry out the battery.
Step 3
- Solder the wires off that are on the battery. Use the solder technique guide for helpful tips!
Solder the wires off that are on the battery. Use the solder technique guide for helpful tips!
Step 4
Screen
- Remove the 4.1 mm screws from the motherboard using the J #000 Phillips Screwdriver.
Remove the 4.1 mm screws from the motherboard using the J #000 Phillips Screwdriver.
Step 5
- Carefully remove the tape connected to the back of the screen and the motherboard.
Carefully remove the tape connected to the back of the screen and the motherboard.
Step 6
- Use the nylon spudger to separate the screen from the plastic casing.
Use the nylon spudger to separate the screen from the plastic casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Katalina Benecke
Member since: 10/10/2016
364 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
Texas Tech, Team 1-13, Bennett Fall 2016
Member of Texas Tech, Team 1-13, Bennett Fall 2016
TTU-BENNETT-F16S1G13
5 Members
6 Guides authored
