Difficulty
Moderate
Steps
7
Time Required
10 - 30 minutes
Sections
2
- MiTM Air Compressors AM1HE0205HD 2014 Safety Precautions
- 2 steps
- Regulator
- 5 steps
Flags
0
BackMi-T-M Air Compressor AM1-HE02-05HD (2014)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power off the compressor
- Before you begin, ensure the device is powered down and cool to the touch.
- Ensure the compressor is unplugged.
- Flip the pressure switch lever up to the off position.
Before you begin, ensure the device is powered down and cool to the touch.
Ensure the compressor is unplugged.
Flip the pressure switch lever up to the off position.
1024
Step 2
Drain the air from the compressor
- Pull the ring on the safety release valve away from the compressor tank to drain the air from the compressor.
- Ensure all air is drained from the tank before beginning repairs.
Pull the ring on the safety release valve away from the compressor tank to drain the air from the compressor.
Ensure all air is drained from the tank before beginning repairs.
Step 3
Remove the air hose quick-connect socket
- Use a 3/4 inch wrench to loosen and remove the air hose quick-connect socket.
Use a 3/4 inch wrench to loosen and remove the air hose quick-connect socket.
Step 4
Remove the pressure gauge
- Use a 7/16 inch wrench to loosen and remove the pressure gauge.
Use a 7/16 inch wrench to loosen and remove the pressure gauge.
Step 5
Remove the regulator
- Use a 5/8" wrench to loosen the air tank nipple from the air tank enough to be able to rotate it with the regulator.
Use a 5/8" wrench to loosen the air tank nipple from the air tank enough to be able to rotate it with the regulator.
Step 6
- Rotate the regulator 180°, so the bottom of the regulator faces away from the compressor motor.
Rotate the regulator 180°, so the bottom of the regulator faces away from the compressor motor.
Step 7
- With a 5/8 inch wrench bracing the air tank nipple, use a 3/4 inch wrench to loosen and remove the regulator.
- Make sure the nipple stays connected to the air tank.
- During reassembly, tighten the air tank nipple to the air tank, and then tighten the regulator to the nipple.
With a 5/8 inch wrench bracing the air tank nipple, use a 3/4 inch wrench to loosen and remove the regulator.
Make sure the nipple stays connected to the air tank.
During reassembly, tighten the air tank nipple to the air tank, and then tighten the regulator to the nipple.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Adam O'Camb
Member since: 04/11/2015
173,479 Reputation
418 Guides authored
Badges:
39
+36 more badges