Difficulty

Easy

Steps

6

Time Required

                          1 - 5 minutes

Sections

1

  • Mio MiVue 698 Disassembly
  • 6 steps

Flags

3

Grammar Police

Embrace your inner English teacher and help improve this guide’s grammar!

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackMio MiVue

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove screws from the top
  • We will disassemble Mio MiVue 698 (Dual) car camera in this guide.
  • On the top of the unit, under the two caps, there are two Philips screws. Remove those caps and use Philips 0 screwdriver.

We will disassemble Mio MiVue 698 (Dual) car camera in this guide.

On the top of the unit, under the two caps, there are two Philips screws. Remove those caps and use Philips 0 screwdriver.

1024

Step 2

              Open it up
  • Now use a prying tool and gently pry all four sides of the display assembly.
  • Be careful not to damage the wire strip on the bottom.

Now use a prying tool and gently pry all four sides of the display assembly.

Be careful not to damage the wire strip on the bottom.

Step 3

              Remove wires
  • Remove black adhesive tape from the contacts.
  • Use a plastic tweezers to gently unlock wire strip from the contacts. You will end up with a disconnected display assembly.

Remove black adhesive tape from the contacts.

Use a plastic tweezers to gently unlock wire strip from the contacts. You will end up with a disconnected display assembly.

Step 4

              Remove board from the case
  • Disconnect the grey wire, which leads to GPS module.
  • Remove three screws that hold the PCB.
  • Remove the microSD card from the unit. Now you have to use a finger to carefully push against the lens from the front of the car camera, so the board will pop out.

Disconnect the grey wire, which leads to GPS module.

Remove three screws that hold the PCB.

Remove the microSD card from the unit. Now you have to use a finger to carefully push against the lens from the front of the car camera, so the board will pop out.

Step 5

              Remove battery
  • The battery is attached to the board with a small piece of tape.

The battery is attached to the board with a small piece of tape.

Step 6

              Remove GPS module
  • Remove two screws so you can remove the GPS module.

Remove two screws so you can remove the GPS module.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Peter

Member since: 01/23/2022

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       1