Difficulty
Difficult
Steps
6
Time Required
30 - 50 minutes
Sections
1
- Trigger
- 6 steps
Flags
0
BackMilwaukee M18 2606-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Trigger
- Remove the seven 18 mm screws, using the T3 Torx Screwdriver, from the handle area of the case.
- Remove the two 21 mm screws, using the T3 Torx Screwdriver, from the top of the case.
Remove the seven 18 mm screws, using the T3 Torx Screwdriver, from the handle area of the case.
Remove the two 21 mm screws, using the T3 Torx Screwdriver, from the top of the case.
1024
Step 2
- Remove the four 20 mm screws, using the T3 Torx Screwdriver, from the front of the case.
Remove the four 20 mm screws, using the T3 Torx Screwdriver, from the front of the case.
Step 3
- Peel back the sticker at the bottom of the drill handle.
Peel back the sticker at the bottom of the drill handle.
Step 4
- Open the case by sliding the opening tool all the way around the case to pry it apart.
Open the case by sliding the opening tool all the way around the case to pry it apart.
Step 5
- Unplug the 4-pin connector, using the tweezers, from the circuit board.
Unplug the 4-pin connector, using the tweezers, from the circuit board.
Step 6
- Desolder the wires soldered to the trigger.
Desolder the wires soldered to the trigger.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Markus Eldridge
Member since: 09/24/2019
853 Reputation
5 Guides authored
Badges:
10
+7 more badges
Team
Embry-Riddle Aeronautical University, Team S1-G10, Watkins Fall 2019
Member of Embry-Riddle Aeronautical University, Team S1-G10, Watkins Fall 2019
ERAU-WATKINS-F19S1G10
4 Members
5 Guides authored
