Milwaukee M18 2606 20 Gearbox Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 - 40 minutes

Sections

Chuck
4 steps
Gearbox
5 steps

Flags

BackMilwaukee M18 2606-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Chuck

Rotate the chuck counterclockwise as far as possible to loosen from the base.

Rotate the chuck counterclockwise as far as possible to loosen from the base.

1024

Step 2

Remove the 28 mm inner screw holding the chuck onto the drill using a Phillips #3 screwdriver.
Rotate the screw clockwise to loosen it.
The inner chuck screw is reverse threaded which is why it needs to be rotated clockwise.

Remove the 28 mm inner screw holding the chuck onto the drill using a Phillips #3 screwdriver.

Rotate the screw clockwise to loosen it.

The inner chuck screw is reverse threaded which is why it needs to be rotated clockwise.

Step 3

Insert an Allen wrench into the chuck and tighten the chuck onto the wrench.
The Allen wrench will be used for leverage when removing the chuck.
When the chuck is tightened it could make a clicking sound. This is fine and is not causing any harm to the drill.

Insert an Allen wrench into the chuck and tighten the chuck onto the wrench.

The Allen wrench will be used for leverage when removing the chuck.

When the chuck is tightened it could make a clicking sound. This is fine and is not causing any harm to the drill.

Step 4

Rotate the Allen wrench counterclockwise to remove the chuck.

Rotate the Allen wrench counterclockwise to remove the chuck.

Step 5

              Gearbox

Using the T3 Torx screwdriver, remove the seven 18 mm screws from the handle area of the case.
Using the T3 Torx screwdriver, remove the two 21 mm screws from the top of the case.

Using the T3 Torx screwdriver, remove the seven 18 mm screws from the handle area of the case.

Using the T3 Torx screwdriver, remove the two 21 mm screws from the top of the case.

Step 6

Using the T3 Torx screwdriver, remove the four 20 mm screws from the front of the case.

Using the T3 Torx screwdriver, remove the four 20 mm screws from the front of the case.

Step 7

Peel back the sticker at the bottom of the drill handle.

Peel back the sticker at the bottom of the drill handle.

Step 8

Open the case by sliding the opening tool all the way around the case to pry it apart.

Open the case by sliding the opening tool all the way around the case to pry it apart.

Step 9

Lift the gearbox slightly and pull away from the motor to remove it from the case .

Lift the gearbox slightly and pull away from the motor to remove it from the case .

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Markus Eldridge

Member since: 09/24/2019

853 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Embry-Riddle Aeronautical University, Team S1-G10, Watkins Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S1-G10, Watkins Fall 2019 



                    ERAU-WATKINS-F19S1G10                     


                                            4 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team