Difficulty
Easy
Steps
4
Time Required
10 minutes
Sections
2
- Outer Casing
- 2 steps
- Forward/Reverse Shuttle
- 2 steps
Flags
0
BackMilwaukee M12 2407-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Casing
- Remove each of the seven 14mm Pan Hd. T-10 ST screws on one side of the housing assembly using the T10 screwdriver.
Remove each of the seven 14mm Pan Hd. T-10 ST screws on one side of the housing assembly using the T10 screwdriver.
1024
Step 2
- Remove metal clip located at the base of the drill, where the battery is to be inserted.
- You may need to use a spudger if the clip is too difficult to remove with your fingers.
Remove metal clip located at the base of the drill, where the battery is to be inserted.
You may need to use a spudger if the clip is too difficult to remove with your fingers.
Step 3
Forward/Reverse Shuttle
- Use both hands to lift and remove the gear case assembly from the shell casing.
- Set the gear case assembly aside.
Use both hands to lift and remove the gear case assembly from the shell casing.
Set the gear case assembly aside.
Step 4
- While holding the shell in one hand, pull the end of the broken forward/reverse shuttle out of the casing.
- Set the broken forward/reverse shuttle aside.
While holding the shell in one hand, pull the end of the broken forward/reverse shuttle out of the casing.
Set the broken forward/reverse shuttle aside.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Skylar Norris
Member since: 02/05/2019
216 Reputation
1 Guide authored
Badges:
8
+5 more badges
Team
Appalachian State University, Team S2-G1, Menagarishvili Spring 2019
Member of Appalachian State University, Team S2-G1, Menagarishvili Spring 2019
APSU-MENAGARISHVILI-S19S2G1
2 Members
5 Guides authored
