Difficulty
Easy
Steps
3
Time Required
15 minutes
Sections
1
- Switch
- 3 steps
Flags
0
BackMilwaukee Hole Hawg 1675-1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Switch
- Ensure that the drill is unplugged.
- Position the drill so that it is on its side.
Ensure that the drill is unplugged.
Position the drill so that it is on its side.
1024
Step 2
- Remove the four 19mm Torx T15 screws.
- Remove the two 25mm Torx T27 screw.
Remove the four 19mm Torx T15 screws.
Remove the two 25mm Torx T27 screw.
Step 3
- Remove the top portion of the handle.
- Pay special attention to where each wire connects.
- Lift up on the switch and disconnect the wires.
- Use a #0 flathead screwdriver to release tension on the wires.
Remove the top portion of the handle.
Pay special attention to where each wire connects.
Lift up on the switch and disconnect the wires.
Use a #0 flathead screwdriver to release tension on the wires.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Rufus Bailey
Member since: 01/20/2020
301 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
South Arkansas Community College, Team S1-G1, Mitchell Spring 2020
Member of South Arkansas Community College, Team S1-G1, Mitchell Spring 2020
SACC-MITCHELL-S20S1G1
4 Members
4 Guides authored
