Difficulty
Moderate
Steps
9
Time Required
20 minutes
Sections
2
- Motor Brushes
- 3 steps
- Field
- 6 steps
Flags
0
BackMilwaukee Hole Hawg 1675-1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor Brushes
- Ensure that the drill is unplugged.
- Position the drill so that it is on its side.
Ensure that the drill is unplugged.
Position the drill so that it is on its side.
1024
Step 2
- Remove the brush cap with a flathead screwdriver.
Remove the brush cap with a flathead screwdriver.
Step 3
- Pry up on the copper brush holder with a screwdriver or spudger.
- Continue lifting up the copper brush holder to remove the brush.
- Repeat on the opposite side.
Pry up on the copper brush holder with a screwdriver or spudger.
Continue lifting up the copper brush holder to remove the brush.
Repeat on the opposite side.
Step 4
Field
- Position the the drill upright and remove the four 19mm Torx T15 screws securing the motor cover.
Position the the drill upright and remove the four 19mm Torx T15 screws securing the motor cover.
Step 5
- Remove the motor cover and withdraw the armature.
- Take note to not lose the washer that sits on top of the armature.
Remove the motor cover and withdraw the armature.
Take note to not lose the washer that sits on top of the armature.
Step 6
- Remove the black insulator ring.
- Remove the two 45mm Torx T15 screws securing the field to the drill.
Remove the black insulator ring.
Remove the two 45mm Torx T15 screws securing the field to the drill.
Step 7
- Position drill on its side.
- Remove the four 19mm Torx T15 screws.
- Remove the two 25mm Torx T27 screws.
- Remove the top portion of the handle.
Position drill on its side.
Remove the four 19mm Torx T15 screws.
Remove the two 25mm Torx T27 screws.
Remove the top portion of the handle.
Step 8
- Lift the switch up and away to allow room to work.
- Uncrimp the wire connector on the yellow field wire attached to the switch to disconnect it.
Lift the switch up and away to allow room to work.
Uncrimp the wire connector on the yellow field wire attached to the switch to disconnect it.
Step 9
- Lift the field out of the device, feeding the yellow wire through the handle.
Lift the field out of the device, feeding the yellow wire through the handle.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Colby Green
Member since: 01/13/2020
183 Reputation
1 Guide authored
Badges:
2
Team
South Arkansas Community College, Team S1-G1, Mitchell Spring 2020
Member of South Arkansas Community College, Team S1-G1, Mitchell Spring 2020
SACC-MITCHELL-S20S1G1
4 Members
4 Guides authored