Difficulty
Difficult
Steps
5
Time Required
15 - 20 minutes
Sections
3
- Battery
- 1 step
- Milwaukee Hex Impact Driver 2753-20 Cover Removal
- 2 steps
- Trigger
- 2 steps
Flags
0
BackMilwaukee Hex Impact Driver 2753-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- While pinching the red locking buttons, pull the battery away from the front of the drill until the battery is fully removed.
- The battery is missing from this device so its removal is being mimed.
While pinching the red locking buttons, pull the battery away from the front of the drill until the battery is fully removed.
The battery is missing from this device so its removal is being mimed.
1024
Step 2
Milwaukee Hex Impact Driver 2753-20 Cover Removal
- Using the Torx T10 screwdriver, remove the six 17 mm screws on the outside of the handle.
- Remove the two 40 mm Torx T10 screws near the bottom of the cover.
Using the Torx T10 screwdriver, remove the six 17 mm screws on the outside of the handle.
Remove the two 40 mm Torx T10 screws near the bottom of the cover.
Step 3
- Carefully remove the cover.
- If there is buildup from sawdust or sediment it might be a little difficult to take apart.
Carefully remove the cover.
If there is buildup from sawdust or sediment it might be a little difficult to take apart.
Step 4
Trigger
- Lift the trigger assembly from the device. It is connected to the circuit board by wires.
- Carefully desolder the wires off of the trigger assembly using a soldering iron on medium heat.
- Refer to this guide for proper desoldering technique.
Lift the trigger assembly from the device. It is connected to the circuit board by wires.
Carefully desolder the wires off of the trigger assembly using a soldering iron on medium heat.
Refer to this guide for proper desoldering technique.
Step 5
- Remove the trigger assembly from the device.
- Replace old trigger assembly with replacement part no. 14-20-0013.
Remove the trigger assembly from the device.
Replace old trigger assembly with replacement part no. 14-20-0013.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Alex Larson
Member since: 01/16/2019
243 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
University of Alabama, Team S2-G3, Bedsole Spring 2019
Member of University of Alabama, Team S2-G3, Bedsole Spring 2019
UA-BEDSOLE-S19S2G3
3 Members
7 Guides authored