Difficulty
Easy
Steps
3
Time Required
15 minutes
Sections
2
- Outer Casing
- 2 steps
- Directional Switch
- 1 step
Flags
0
BackMilwaukee Hex Impact Driver 2750-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Casing
- Remove the five T9 15.5 mm screws.
- Remove the single T9 19.5mm screw.
- Remove the two T9 37mm screws.
Remove the five T9 15.5 mm screws.
Remove the single T9 19.5mm screw.
Remove the two T9 37mm screws.
1024
Step 2
- Remove the drill casing to expose the drill’s interior parts.
Remove the drill casing to expose the drill’s interior parts.
Step 3
Directional Switch
- Remove the trigger assembly completely.
- Remove the directional switch by lifting upward using a pair of tweezers, clearing the alignment pole on the trigger assembly.
- Insert a new directional switch by aligning the hole on the switch with the pole on the trigger.
Remove the trigger assembly completely.
Remove the directional switch by lifting upward using a pair of tweezers, clearing the alignment pole on the trigger assembly.
Insert a new directional switch by aligning the hole on the switch with the pole on the trigger.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Charles Putnam
Member since: 02/12/2019
409 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
Western Carolina University, Team S1-G1, Virtue Spring 2019
Member of Western Carolina University, Team S1-G1, Virtue Spring 2019
WCU-VIRTUE-S19S1G1
4 Members
5 Guides authored
