Difficulty
Moderate
Steps
4
Time Required
5 minutes
Sections
2
- Outer Casing
- 2 steps
- Chuck Drive Shaft
- 2 steps
Flags
0
BackMilwaukee Hex Impact Driver 2750-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Casing
- Remove the five T9 15.5 mm screws.
- Remove the single T9 19.5mm screw.
- Remove the two T9 37mm screws.
Remove the five T9 15.5 mm screws.
Remove the single T9 19.5mm screw.
Remove the two T9 37mm screws.
1024
Step 2
- Remove the drill casing to expose the drill’s interior parts.
Remove the drill casing to expose the drill’s interior parts.
Step 3
Chuck Drive Shaft
- Pulling directly outward, remove the driver head from the motor assembly by picking it up out of the casing.
Pulling directly outward, remove the driver head from the motor assembly by picking it up out of the casing.
Step 4
- Remove the drive shaft assembly from the motor coils.
- There will be resistance when removing the drive shaft as there is magnetism working against you.
Remove the drive shaft assembly from the motor coils.
There will be resistance when removing the drive shaft as there is magnetism working against you.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Charles Putnam
Member since: 02/12/2019
409 Reputation
5 Guides authored
Badges:
5
+2 more badges
Team
Western Carolina University, Team S1-G1, Virtue Spring 2019
Member of Western Carolina University, Team S1-G1, Virtue Spring 2019
WCU-VIRTUE-S19S1G1
4 Members
5 Guides authored