Difficulty

Difficult

Steps

5

Time Required

                          20 minutes

Sections

3

  • Battery
  • 1 step
  • Milwaukee Hex Impact Driver 2656-20 Case Disassembly
  • 1 step
  • Trigger Assembly
  • 3 steps

Flags

0

  • BackMilwaukee Hex Impact Driver 2656-20

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Squeeze the red buttons on the battery.
  • While squeezing the red buttons, slide the battery forward and out to remove it from the device.

Squeeze the red buttons on the battery.

While squeezing the red buttons, slide the battery forward and out to remove it from the device.

1024

Step 2

              Milwaukee Hex Impact Driver 2656-20 Case  Disassembly
  • Lay the impact driver on its side.
  • Remove eight 16 mm and a single 19 mm screws using the T10 Torx Screwdriver.
  • Separate the two halves by pulling up on the top half.
  • Make sure that the half with the screw heads Is facing up during this process. This will ensure that the components do not fall out.
  • Lay the top half to the side.

Lay the impact driver on its side.

Remove eight 16 mm and a single 19 mm screws using the T10 Torx Screwdriver.

Separate the two halves by pulling up on the top half.

Make sure that the half with the screw heads Is facing up during this process. This will ensure that the components do not fall out.

Lay the top half to the side.

Step 3

              Trigger Assembly
  • Remove the two 6 mm screws on the back of the brush card assembly using the T10 Torx screwdriver.
  • Move the two wires out of the way.

Remove the two 6 mm screws on the back of the brush card assembly using the T10 Torx screwdriver.

Move the two wires out of the way.

Step 4

  • Gently pull up on the trigger assembly to remove it from the case.

Gently pull up on the trigger assembly to remove it from the case.

Step 5

  • Remove the trigger assembly from the device.

Remove the trigger assembly from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Troy Conrad

Member since: 09/16/2019

97 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Embry-Riddle Aeronautical University, Team S24-G2, McClure Fall 2019                        

                                                  Member of Embry-Riddle Aeronautical University, Team S24-G2, McClure Fall 2019 



                    ERAU-MCCLURE-F19S24G2                     


                                            4 Members                     


                                            9 Guides authored