Difficulty
Moderate
Steps
5
Time Required
10 - 20 minutes
Sections
2
- Housing Assembly
- 2 steps
- Power Cord
- 3 steps
Flags
1
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
BackMilwaukee 5262-21
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Housing Assembly
- Remove the ten 19mm T20 Torx screws shown in red.
Remove the ten 19mm T20 Torx screws shown in red.
1024
Step 2
- Remove the red Housing Assembly by lifting it up off of the tool.
Remove the red Housing Assembly by lifting it up off of the tool.
Step 3
Power Cord
- Remove the two 11.5mm T-15 screws shown in red.
Remove the two 11.5mm T-15 screws shown in red.
Step 4
- Follow the black and white cord to the trigger.
- On the trigger there are two small bolts that you have to loosen.
- Loosen them slightly with a H - 1.5 bit.
Follow the black and white cord to the trigger.
On the trigger there are two small bolts that you have to loosen.
Loosen them slightly with a H - 1.5 bit.
Step 5
- Once the bolts are loose you can pull both cords straight out from the trigger.
- Pull the cable from the chassis and put it to the side and it has been successfully removed.
Once the bolts are loose you can pull both cords straight out from the trigger.
Pull the cable from the chassis and put it to the side and it has been successfully removed.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Adrien Andrade-Cain
Member since: 03/08/2019
181 Reputation
2 Guides authored
Badges:
3
Team
UMass Dartmouth, Team S1-G3, Botvin Spring 2019
Member of UMass Dartmouth, Team S1-G3, Botvin Spring 2019
UMASSD-BOTVIN-S19S1G3
4 Members
6 Guides authored