Difficulty
Moderate
Steps
4
Time Required
10 - 20 minutes
Sections
1
- Trigger Assembly
- 4 steps
Flags
0
BackMilwaukee 2780-20
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Trigger Assembly
- Using a Torx T20 screwdriver, unscrew the four 16mm screws from the case.
- Switch to the Torx T10 screwdriver, and remove the last 16mm screw from the hilt.
Using a Torx T20 screwdriver, unscrew the four 16mm screws from the case.
Switch to the Torx T10 screwdriver, and remove the last 16mm screw from the hilt.
1024
Step 2
- Using the Torx T20 screwdriver, unscrew the four 28mm screws located at the bottom (and top) of the gearcase assembly.
- Remove the two 12mm screws with a Torx T20 screwdriver in order to get to the others.
Using the Torx T20 screwdriver, unscrew the four 28mm screws located at the bottom (and top) of the gearcase assembly.
Remove the two 12mm screws with a Torx T20 screwdriver in order to get to the others.
Step 3
- Pull apart the housing handles.
Pull apart the housing handles.
Step 4
- Lift the trigger assembly off of its mount.
- Dispose of the old trigger assembly and install the new one.
Lift the trigger assembly off of its mount.
Dispose of the old trigger assembly and install the new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Chris Hopper
Member since: 08/22/2019
468 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
South Arkansas Community College, Team S1-G1, Mitchell Fall 2019
Member of South Arkansas Community College, Team S1-G1, Mitchell Fall 2019
SACC-MITCHELL-F19S1G1
4 Members
5 Guides authored
