Difficulty

Moderate

Steps

4

Time Required

                          30 minutes

Sections

1

  • polarity of motor
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackMilchschäumer Aerolatte

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove bottom plate
  • Remove the three screws with a screwdriver PH2
  • There is a little triangle impressed in the bottom plate to show the position of the on-switch.

Remove the three screws with a screwdriver PH2

There is a little triangle impressed in the bottom plate to show the position of the on-switch.

1024

Step 2

  • Pull the bottom plate as far away from the housing as possible.
  • A red and a blue cable connect the motor and a plug. Pull out the plug from the circuit board.

Pull the bottom plate as far away from the housing as possible.

A red and a blue cable connect the motor and a plug. Pull out the plug from the circuit board.

Step 3

  • On one side of the plug you see two slots. You can see the cable shoes in there.
  • With something pointed (eg. watchmaker’s screwdriver) you press in one slot to open the cable shoe’s locking catch. At the same time you pull on the cable.
  • Do the same with the second cable.
  • Exchange the position of the cables and push the cable shoes back in the plug.

On one side of the plug you see two slots. You can see the cable shoes in there.

With something pointed (eg. watchmaker’s screwdriver) you press in one slot to open the cable shoe’s locking catch. At the same time you pull on the cable.

Do the same with the second cable.

Exchange the position of the cables and push the cable shoes back in the plug.

Step 4

  • The milk frother is re-assambled in reverse order.
  • Plug in the device, fill in some liquid an press the “cold foam” button. Now the motor should turn again. At the first time it might be necessary to give a little push by hand. The motor speed increases fast and remains.

The milk frother is re-assambled in reverse order.

Plug in the device, fill in some liquid an press the “cold foam” button. Now the motor should turn again. At the first time it might be necessary to give a little push by hand. The motor speed increases fast and remains.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             


        John Maier is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

John Maier

Author

                                      with 1 other contributor 


                    John Maier

Member since: 08/29/2017

1,207 Reputation

                                      3 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

John Maier - Dec 17, 2019

Reply

Bei unserem bauähnlichen Milchschäumer Petra ließ sich das gleiche Problem genauso beheben.