Difficulty
Moderate
Steps
5
Time Required
15 - 20 minutes
Sections
2
- Case
- 3 steps
- Hard Drive
- 2 steps
Flags
0
BackMicrosoft Zune 80
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Case
- Use a metal spudger or Zune opening tool to remove the small silver plastic cap on top of the device.
Use a metal spudger or Zune opening tool to remove the small silver plastic cap on top of the device.
1024
Step 2
- There are two T4 screws under the cap. Remove both with a T4 screwdriver.
- Be careful removing the screws; the screw heads can break very easily.
There are two T4 screws under the cap. Remove both with a T4 screwdriver.
Be careful removing the screws; the screw heads can break very easily.
Step 3
Remove the Casing
- Using a metal spudger or Zune opening tool, remove the aluminum backing starting from the top. There are 5 clips on each side and two on the bottom.
- Be careful not to press the tools in too far; there are exposed cables right inside the edge of the device.
Using a metal spudger or Zune opening tool, remove the aluminum backing starting from the top. There are 5 clips on each side and two on the bottom.
Be careful not to press the tools in too far; there are exposed cables right inside the edge of the device.
Step 4
Remove the Silver Tape
- Remove the silver tape from the bottom center and the top right. This allows access to the hard drive and the battery.
Remove the silver tape from the bottom center and the top right. This allows access to the hard drive and the battery.
Step 5
- Unclick the black bar connecting the orange hard drive cable to the bottom of the hard drive. Gently push towards the bottom of the device on the black bar until you hear a click sound, it is now disengaged from the hard drive.
- If the cable doesn’t come off easily, the black bar has not been un-clicked.
- The hard drive cable (ZIF cable) is very fragile. Try to keep it in its original shape and bend it as little as possible.
- Now gently pull the orange hard drive cable to remove it from the hard drive.
- Lift the hard drive from the device.
- Hard Drive Replacement Only: Check to make sure the hard drive cable is in good condition and then connect the new hard drive in the same place, following the steps in reverse order.
Unclick the black bar connecting the orange hard drive cable to the bottom of the hard drive. Gently push towards the bottom of the device on the black bar until you hear a click sound, it is now disengaged from the hard drive.
If the cable doesn’t come off easily, the black bar has not been un-clicked.
The hard drive cable (ZIF cable) is very fragile. Try to keep it in its original shape and bend it as little as possible.
Now gently pull the orange hard drive cable to remove it from the hard drive.
Lift the hard drive from the device.
Hard Drive Replacement Only: Check to make sure the hard drive cable is in good condition and then connect the new hard drive in the same place, following the steps in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
7 other people completed this guide.
Author
with 11 other contributors
turey
Member since: 11/11/2009
357 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
Cal Poly, Team 6-5, Maness Fall 2009
Member of Cal Poly, Team 6-5, Maness Fall 2009
CPSU-MANESS-F09S6G5
5 Members
5 Guides authored