Difficulty
Moderate
Steps
8
Time Required
10 - 15 minutes
Sections
1
- Battery and Hard Drive
- 8 steps
Flags
2
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackMicrosoft Zune 30 GB
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery and Hard Drive
- Tools that are needed to replace the battery and the hard drive
- small Phillips screwdriver
- small jewelers flat head screwdriver
- case opening tool, I use my trusty Ipod opener :)
- definitely glasses if you are supposed to have them. Some of this stuff is really small.
Tools that are needed to replace the battery and the hard drive
small Phillips screwdriver
small jewelers flat head screwdriver
case opening tool, I use my trusty Ipod opener :)
definitely glasses if you are supposed to have them. Some of this stuff is really small.
1024
Step 2
- Start off by removing the spacer from the bottom dock port. It is just pushed in, so all you need is a small jeweler’s screwdriver to pry it out. Use the smaller ends of the port as the pry point so you don’t break the spacer.
Start off by removing the spacer from the bottom dock port. It is just pushed in, so all you need is a small jeweler’s screwdriver to pry it out. Use the smaller ends of the port as the pry point so you don’t break the spacer.
Step 3
- Next remove the two small Phillips screws.
Next remove the two small Phillips screws.
Step 4
- Now it is time to open the case. I used my trusty Ipod opening tools and started on the longer side of the Zune. Just like the Ipod, take your time and carefully open the case. Sometimes it works better if you use two tools. Once it opens, be CAREFUL around the headphone jack when you lift up the case. Lift it slwoly at the port end and then the headphone end. The headphone seems to extend a little into the case and you DO NOT want to break it of the board….
Now it is time to open the case. I used my trusty Ipod opening tools and started on the longer side of the Zune. Just like the Ipod, take your time and carefully open the case. Sometimes it works better if you use two tools. Once it opens, be CAREFUL around the headphone jack when you lift up the case. Lift it slwoly at the port end and then the headphone end. The headphone seems to extend a little into the case and you DO NOT want to break it of the board….
Step 5
- Now with the backing off we have free access to the battery and the hard drive caddy.
Now with the backing off we have free access to the battery and the hard drive caddy.
Step 6
- Disconnect the battery by lifting the brown slide gently up, freeing the cable. You can now safely remove the battery. Disconnect the clickwheel cable afterwards.
Disconnect the battery by lifting the brown slide gently up, freeing the cable. You can now safely remove the battery. Disconnect the clickwheel cable afterwards.
Step 7
- Now remove the 4 screws holding the drive case as well as the clip for the battery on the board .
Now remove the 4 screws holding the drive case as well as the clip for the battery on the board .
Step 8
- With the battery and the four screws for for the hard drive caddy removed, lift the caddy up and flip it toward the headphone end of the Zune. Remove the hard drive cable clip by opening the black clip on the connector. Use your fingernails or the iPod tool to move the clip carefully to the open position. Take off the sticky tape to reveal the hard drive bumpers. Remove them to free the hard drive. Now replace the hard drive and reassemble the Zune.
With the battery and the four screws for for the hard drive caddy removed, lift the caddy up and flip it toward the headphone end of the Zune. Remove the hard drive cable clip by opening the black clip on the connector. Use your fingernails or the iPod tool to move the clip carefully to the open position. Take off the sticky tape to reveal the hard drive bumpers. Remove them to free the hard drive. Now replace the hard drive and reassemble the Zune.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
7 other people completed this guide.
Author
with 7 other contributors
oldturkey03
Member since: 09/29/2010
722,305 Reputation
109 Guides authored
Badges:
53
+50 more badges
Team
Global Fixers
Member of Global Fixers
Community
22 Members
240 Guides authored