Difficulty

Moderate

Steps

6

Time Required

                          10 - 30 minutes            

Sections

3

  • Safety Precautions
  • 1 step
  • Upper Shell Removal
  • 2 steps
  • Spark Plug
  • 3 steps

Flags

0

  • BackMi-T-M Heater MH-0190-0M10 (2014)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Safety precautions               
  • Power off the machine at least one hour prior to starting repairs. Ensure the machine is completely cool to the touch.
  • Flip the power switch into the OFF position.
  • Unplug any extension cords from the included power cord.

Power off the machine at least one hour prior to starting repairs. Ensure the machine is completely cool to the touch.

Flip the power switch into the OFF position.

Unplug any extension cords from the included power cord.

1024

Step 2

              Remove the upper shell               
  • Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.

Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.

Step 3

  • Lift the upper shell straight up off of the machine to remove it.

Lift the upper shell straight up off of the machine to remove it.

Step 4

              Disconnect the spark plug wires               
  • Grab the spark plug wires by their boots and pull firmly to disconnect them from the spark plug.

Grab the spark plug wires by their boots and pull firmly to disconnect them from the spark plug.

Step 5

              Remove the spark plug               
  • Use a 5/16 inch socket or Phillips screwdriver to remove the bolt securing the spark plug.
  • During reassembly, install the insulating washer against the spark plug and the lock washer against the bolt.

Use a 5/16 inch socket or Phillips screwdriver to remove the bolt securing the spark plug.

During reassembly, install the insulating washer against the spark plug and the lock washer against the bolt.

Step 6

  • Remove the spark plug.
  • During reassembly, insert the new spark plug with the leads angled towards the center of the combustion chamber.

Remove the spark plug.

During reassembly, insert the new spark plug with the leads angled towards the center of the combustion chamber.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Sam Omiotek                     

Member since: 02/25/2019

55,294 Reputation

                                      288 Guides authored                  



                       Badges:
                       35







                                                        +32 more badges                           

Team

                       Guide Team                        

                                                  Member of Guide Team 



                    Community                     


                                            10 Members                     


                                            9,216 Guides authored