Difficulty

Moderate

Steps

6

Time Required

                          15 - 30 minutes

Sections

3

  • Safety Precautions
  • 1 step
  • Upper Shell Removal
  • 2 steps
  • Capacitor
  • 3 steps

Flags

0

  • BackMi-T-M Heater MH-0190-0M10 (2014)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Safety precautions
  • Power off the machine at least one hour prior to starting repairs. Ensure the machine is completely cool to the touch.
  • Flip the power switch into the OFF position.
  • Unplug any extension cords from the included power cord.

Power off the machine at least one hour prior to starting repairs. Ensure the machine is completely cool to the touch.

Flip the power switch into the OFF position.

Unplug any extension cords from the included power cord.

1024

Step 2

              Remove the upper shell
  • Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.

Use a 5/16 inch socket or Phillips screwdriver to remove the eight screws securing the upper shell, four on each side.

Step 3

  • Lift the upper shell straight up off of the machine to remove it.

Lift the upper shell straight up off of the machine to remove it.

Step 4

              Disconnect the capacitor
  • Grip the black and white wires by their connectors and pull firmly to remove them from the capacitor.
  • During reassembly, install the white and black wires on the same terminals as they were installed on the original capacitor.

Grip the black and white wires by their connectors and pull firmly to remove them from the capacitor.

During reassembly, install the white and black wires on the same terminals as they were installed on the original capacitor.

Step 5

              Remove the capacitor
  • Use a Phillips screwdriver to remove the screw securing the capacitor band clamp.

Use a Phillips screwdriver to remove the screw securing the capacitor band clamp.

Step 6

  • Remove the capacitor.
  • During reassembly, align the foam padding between the capacitor and the band clamp.

Remove the capacitor.

During reassembly, align the foam padding between the capacitor and the band clamp.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Sam Omiotek

Member since: 02/25/2019

55,294 Reputation

                                      288 Guides authored                  



                       Badges:
                       35







                                                        +32 more badges

Team

                       Guide Team                        

                                                  Member of Guide Team 



                    Community                     


                                            10 Members                     


                                            9,216 Guides authored