Difficulty
Moderate
Steps
4
Time Required
5 minutes
Sections
1
- Gaskets
- 4 steps
Flags
0
BackMerchSource the Black Series Boat Racers
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Gaskets
- Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.
- Screw length is 16 mm.
Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.
Screw length is 16 mm.
1024
Step 2
- Remove the top of the boat by sliding it backwards and then pulling it off.
Remove the top of the boat by sliding it backwards and then pulling it off.
Step 3
- Grab the rubber gasket with tweezers and pull it out of the slot.
Grab the rubber gasket with tweezers and pull it out of the slot.
Step 4
- Gently remove the gasket and replace with a new one.
Gently remove the gasket and replace with a new one.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Monica Reece
Member since: 08/31/2018
672 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Western Carolina University, Team S1-G3, Virtue Fall 2018
Member of Western Carolina University, Team S1-G3, Virtue Fall 2018
WCU-VIRTUE-F18S1G3
4 Members
5 Guides authored