Meizu Mx3 Volume Control And Power Button Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Volume Control and Power Button
4 steps

Flags

Slice and Dice

The steps in this guide should be split up and made into a series of prerequisite guides.

BackMeizu MX3
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Removing the Back Cover

Insert the plastic opening tool in between the charging port and the back case of the device. Slowly move the tool to the left of the until you come the top by the power button.
Using a paper clip or pointed edge spudger push in the pin located in the bottom right hand corner of the back of the phone.

Insert the plastic opening tool in between the charging port and the back case of the device. Slowly move the tool to the left of the until you come the top by the power button.

Using a paper clip or pointed edge spudger push in the pin located in the bottom right hand corner of the back of the phone.

1024

Step 2

              Removing the Screws in the Internal Casing

Using one of the small Phillips screwdriver bits provided unscrew the 11 screws present on the protective plastic plate under the device case.

Using one of the small Phillips screwdriver bits provided unscrew the 11 screws present on the protective plastic plate under the device case.

Step 3

              Removing the Internal Casing

After the 11 screws are loosened use the plastic opening tool and gently pry the protective plate from the back of the device.
Once the plate is off, use the same tool to gently remove the 3 ribbon cables located directly above the battery.
On the left side of the battery on the phone case, there is a groove where the plastic opening tool can be inserted to pry the battery up and out. The battery might be glued to the phone so exercise caution.
Note: The battery and motherboard does not need to be removed in order replace power and volume buttons.

After the 11 screws are loosened use the plastic opening tool and gently pry the protective plate from the back of the device.

Once the plate is off, use the same tool to gently remove the 3 ribbon cables located directly above the battery.

On the left side of the battery on the phone case, there is a groove where the plastic opening tool can be inserted to pry the battery up and out. The battery might be glued to the phone so exercise caution.

Note: The battery and motherboard does not need to be removed in order replace power and volume buttons.

Step 4

              Removing the Power and Volume Buttons

After the plastic plate is removed, tweezers can be used to remove and replace the power and volume buttons from the device.

After the plastic plate is removed, tweezers can be used to remove and replace the power and volume buttons from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Mandela Robin

Member since: 09/23/2014

861 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 15-2, Remmell Fall 2014                        

                                                  Member of USF Tampa, Team 15-2, Remmell Fall 2014 



                    USFT-REMMELL-F14S15G2                     


                                            4 Members                     


                                            15 Guides authored

Slice and Dice#

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Slice and Dice

Introduction

What you need

Team