Difficulty
Easy
Steps
7
Time Required
5 - 10 minutes
Sections
1
- Rear Mudguard
- 7 steps
Flags
0
BackE-Scooter
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
The mudguard serves as a manual brake for the scooter as well as providing a tail light, so when this piece has taken too much damage or stops working, it removes an important function to your scooter.
The process for this replacement is simple and does not require a lot of experience or prior information in order to complete.
What you need
Step 1
Rear Mudguard
- Hold down the power button and wait for a beep to ensure that the scooter is turned off.
Hold down the power button and wait for a beep to ensure that the scooter is turned off.
1024
Step 2
- Put up the kickstand so that the scooter is upright.
Put up the kickstand so that the scooter is upright.
Step 3
- Unscrew the old mudguard.
Unscrew the old mudguard.
Step 4
- Grip the wheel and pull off the mudguard.
Grip the wheel and pull off the mudguard.
Step 5
- Remove the connector.
Remove the connector.
Step 6
- Attach the new mudguard’s power connector.
Attach the new mudguard’s power connector.
Step 7
- Line up the new mudguard with the screw holes and reinsert the screws.
Line up the new mudguard with the screw holes and reinsert the screws.
If these steps are followed correctly, then your manual break and tail light should function good as new!
Cancel: I did not complete this guide.
Author
with 2 other contributors
Andrew DiCapo
Member since: 09/28/2021
145 Reputation
1 Guide authored
Badges:
2
Team
University of North Texas, Team 2-9, Raign Fall 2021
Member of University of North Texas, Team 2-9, Raign Fall 2021
UNT-RAIGN-F21S2G9
2 Members
1 Guide authored