Difficulty
Moderate
Steps
7
Time Required
4 hours
Sections
1
- Resistor
- 7 steps
Flags
4
Action Shots
Be an action hero! This guide needs images that better demonstrate how to perform specific actions.
Confusing Text
Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Missed a Step
Oops! This guide is currently missing some important steps.
BackMaytag Neptune dryer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
In these kinds of cases, when users put their clothes in the dryer, the clothes get some heat but do not dry properly and that is mainly because of problems with the drying element. Sometimes people/technicians use ammeters to check if things are functioning properly or not.
Before beginning, make sure to unplug your dryer completely and disconnect from any external power source.
What you need
Step 1
Resistor
- Make sure you unplug everything before you start this project.
- Disassemble the four sockets found behind the control board using a screwdriver to remove the front panel.
Make sure you unplug everything before you start this project.
Disassemble the four sockets found behind the control board using a screwdriver to remove the front panel.
1024
Step 2
- Unscrew the screws to remove the front of the machine.
- This is where you can use a drill to make things easier and faster.
Unscrew the screws to remove the front of the machine.
This is where you can use a drill to make things easier and faster.
Step 3
- Slowly unplug the plugs from the front of the machine.
Slowly unplug the plugs from the front of the machine.
Step 4
- Clean up the surroundings using a piece of cloth and make sure it is ready.
Clean up the surroundings using a piece of cloth and make sure it is ready.
Step 5
- Test the resistor and check the model.
Test the resistor and check the model.
Step 6
- Unplug the components and unscrew the resistor cover using a screwdriver.
Unplug the components and unscrew the resistor cover using a screwdriver.
Step 7
- Finally replace it and put it back the way it was.
Finally replace it and put it back the way it was.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Mustafa Jama
Member since: 05/05/2020
145 Reputation
1 Guide authored
Badges:
2
Team
UW Tacoma, Team S1-G9, Cardinal Spring 2020
Member of UW Tacoma, Team S1-G9, Cardinal Spring 2020
UWT-CARDINAL-S20S1G9
1 Member
1 Guide authored