Difficulty

Moderate

Steps

15

Time Required

                          6 minutes

Sections

3

  • Bottom Cover
  • 5 steps
  • Battery
  • 1 step
  • Screen
  • 9 steps

Flags

1

Inconsistent Images

Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.

  • BackMaylong MN-1000P

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Bottom Cover
  • Place the netbook top down, with the opening of the netbook facing you.

Place the netbook top down, with the opening of the netbook facing you.

1024

Step 2

  • Remove the six 6mm Phillips #00 screws from the netbook.

Remove the six 6mm Phillips #00 screws from the netbook.

Step 3

  • Remove the sticker in the middle of the netbook.
  • Remove the middle 6mm Phillips #00 screw.

Remove the sticker in the middle of the netbook.

Remove the middle 6mm Phillips #00 screw.

Step 4

  • Using two plastic opening tools, pry off the bottom of the netbook by going around the edges.

Using two plastic opening tools, pry off the bottom of the netbook by going around the edges.

Step 5

  • Remove the bottom of the netbook by lifting the corners.

Remove the bottom of the netbook by lifting the corners.

Step 6

              Battery
  • Pinch the red and black wires connected to the section closest to the small white connector, and pull to remove them from the motherboard.

Pinch the red and black wires connected to the section closest to the small white connector, and pull to remove them from the motherboard.

Step 7

              Screen
  • Remove the six 6mm Phillips #00 screws from both sides of the netbook.

Remove the six 6mm Phillips #00 screws from both sides of the netbook.

Step 8

  • Pull the top of the computer and the back side of the computer away from each other until they are detached.
  • Flip the entire computer over so you can see both the screen and keyboard.

Pull the top of the computer and the back side of the computer away from each other until they are detached.

Flip the entire computer over so you can see both the screen and keyboard.

Step 9

  • Remove all the black circular pads from around the screen.
  • Remove all 6mm Phillips #00 screws from around the screen bezel.

Remove all the black circular pads from around the screen.

Remove all 6mm Phillips #00 screws from around the screen bezel.

Step 10

  • Using a plastic opening tool, pry off the screen bezel.
  • After detaching the screen bezel, pull up on the bezel near the hinge area.

Using a plastic opening tool, pry off the screen bezel.

After detaching the screen bezel, pull up on the bezel near the hinge area.

Step 11

  • Use tweezers to gently pull on the black and white wires at the top of the netbook until the white connector detaches.

Use tweezers to gently pull on the black and white wires at the top of the netbook until the white connector detaches.

Step 12

  • Use your fingers to pull on the green, red, black, and white intertwined wires at the bottom of the netbook until the white connector detaches.

Use your fingers to pull on the green, red, black, and white intertwined wires at the bottom of the netbook until the white connector detaches.

Step 13

  • Detach the wide yellow ribbon cable connected to the screen from the computer.

Detach the wide yellow ribbon cable connected to the screen from the computer.

Step 14

  • Flip the computer over.
  • Disconnect the red, green, black, and white intertwined wires from the connector to the motherboard.

Flip the computer over.

Disconnect the red, green, black, and white intertwined wires from the connector to the motherboard.

Step 15

  • Remove the black tape holding down the red, green, black, and white intertwined wires.
  • Remove the screen.

Remove the black tape holding down the red, green, black, and white intertwined wires.

Remove the screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    katelyn buckman

Member since: 01/13/2020

553 Reputation

                                      5 Guides authored                  



                       Badges:
                       3

Team

                       Eastern Washington University, Team S1-G3, Carnegie Winter 2020                        

                                                  Member of Eastern Washington University, Team S1-G3, Carnegie Winter 2020 



                    EWU-CARNEGIE-W20S1G3                     


                                            3 Members                     


                                            5 Guides authored