Difficulty
Moderate
Steps
6
Time Required
6 minutes
Sections
2
- Bottom Cover
- 5 steps
- Battery
- 1 step
Flags
0
BackMaylong MN-1000P
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bottom Cover
- Place the netbook top down, with the opening of the netbook facing you.
Place the netbook top down, with the opening of the netbook facing you.
1024
Step 2
- Remove the six 6mm Phillips #00 screws from the netbook.
Remove the six 6mm Phillips #00 screws from the netbook.
Step 3
- Remove the sticker in the middle of the netbook.
- Remove the middle 6mm Phillips #00 screw.
Remove the sticker in the middle of the netbook.
Remove the middle 6mm Phillips #00 screw.
Step 4
- Using two plastic opening tools, pry off the bottom of the netbook by going around the edges.
Using two plastic opening tools, pry off the bottom of the netbook by going around the edges.
Step 5
- Remove the bottom of the netbook by lifting the corners.
Remove the bottom of the netbook by lifting the corners.
Step 6
Battery
- Pinch the red and black wires connected to the section closest to the small white connector, and pull to remove them from the motherboard.
Pinch the red and black wires connected to the section closest to the small white connector, and pull to remove them from the motherboard.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
katelyn buckman
Member since: 01/13/2020
553 Reputation
5 Guides authored
Badges:
3
Team
Eastern Washington University, Team S1-G3, Carnegie Winter 2020
Member of Eastern Washington University, Team S1-G3, Carnegie Winter 2020
EWU-CARNEGIE-W20S1G3
3 Members
5 Guides authored
