Difficulty

Moderate

Steps

5

Time Required

                          15 - 20 minutes

Sections

1

  • Back Hard Case
  • 5 steps

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackMaxWest TAB-7360DC

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Back Hard Case
  • Insert plastic opening tool at the corner of the screen, in between the back case and the front.
  • Volume buttons will fall out during removal.
  • When opening up the case, have the I/O ports facing you and turn the back case towards the right. There is a short wire connecting the speaker to the logic board.

Insert plastic opening tool at the corner of the screen, in between the back case and the front.

Volume buttons will fall out during removal.

When opening up the case, have the I/O ports facing you and turn the back case towards the right. There is a short wire connecting the speaker to the logic board.

1024

Step 2

  • Carefully pry the tape from the battery, the bottom left chip, and the ribbon cable towards the bottom-right of the board. The bottom left has a little silver square component that must also be unclipped and untaped.
  • The battery is glued to the back of the screen; therefore pull the battery off of the back with caution. There will be resistance but that’s okay.

Carefully pry the tape from the battery, the bottom left chip, and the ribbon cable towards the bottom-right of the board. The bottom left has a little silver square component that must also be unclipped and untaped.

The battery is glued to the back of the screen; therefore pull the battery off of the back with caution. There will be resistance but that’s okay.

Step 3

  • Gently unclip the data cable retainers and remove the wires from the junctions.
  • Peel the tape off the wire near the bottom of the case.

Gently unclip the data cable retainers and remove the wires from the junctions.

Peel the tape off the wire near the bottom of the case.

Step 4

  • Remove the two 4mm screws (circled in orange) with a 00 Phillips head driver.
  • Unclip the black plastic retainer near the data port. The PCB should now be able to be gently pulled off.

Remove the two 4mm screws (circled in orange) with a 00 Phillips head driver.

Unclip the black plastic retainer near the data port. The PCB should now be able to be gently pulled off.

Step 5

  • Make contact with the battery terminals with the hot tip of the soldering iron for a few seconds while slowly pulling the wire away.
  • DO NOT TOUCH BOTH THE BLACK AND RED LEADS AT THE SAME TIME WITH THE SOLDERING IRON

Make contact with the battery terminals with the hot tip of the soldering iron for a few seconds while slowly pulling the wire away.

DO NOT TOUCH BOTH THE BLACK AND RED LEADS AT THE SAME TIME WITH THE SOLDERING IRON

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Gillian Bundles

Member since: 03/21/2018

221 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S4-G3, Baechle Spring 2018                        

                                                  Member of IUPUI, Team S4-G3, Baechle Spring 2018 



                    IUPUI-BAECHLE-S18S4G3                     


                                            4 Members                     


                                            6 Guides authored