Difficulty
Moderate
Steps
5
Time Required
6 - 10 minutes
Sections
1
- Eyes
- 5 steps
Flags
0
BackMatchbox Dino Trapper Trailer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Eyes
- Open the jaw of the T-Rex to reveal the screw on the roof of its mouth.
Open the jaw of the T-Rex to reveal the screw on the roof of its mouth.
1024
Step 2
- Using a JIS #1 screwdriver, remove the 9.6mm screw.
Using a JIS #1 screwdriver, remove the 9.6mm screw.
Step 3
- Using tweezers or wire cutters for tension, remove the cover to reveal the LED assembly.
Using tweezers or wire cutters for tension, remove the cover to reveal the LED assembly.
Step 4
- Remove the plastic cover from the top of the LED.
Remove the plastic cover from the top of the LED.
Step 5
- Hold the LED to remove slack from the wires, and cut the wires as shown to remove the faulty LED.
Hold the LED to remove slack from the wires, and cut the wires as shown to remove the faulty LED.
To reassemble your device, follow these instructions in reverse order. Use a soldering station to solder new LED onto the fresh-cut wires.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Vincent Crabtree
Member since: 03/27/2018
267 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
IUPUI, Team S3-G3, Harley Spring 2018
Member of IUPUI, Team S3-G3, Harley Spring 2018
IUPUI-HARLEY-S18S3G3
3 Members
2 Guides authored
