Difficulty
Difficult
Steps
5
Time Required
15 minutes
Sections
2
- Master and Dynamic MW50 Disassembly
- 3 steps
- Right/Left Speaker
- 2 steps
Flags
0
BackMaster and Dynamic MW50
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Master and Dynamic MW50 Disassembly
- Pull the cushion off of the desired side by gripping the top of the headphones and pulling the cushion off.
Pull the cushion off of the desired side by gripping the top of the headphones and pulling the cushion off.
1024
Step 2
- Remove the four 5mm screws from the earpiece with a Y1 Triwing screwdriver.
Remove the four 5mm screws from the earpiece with a Y1 Triwing screwdriver.
Step 3
- Use the Jimmy to lift up the black cover to get inside the device.
Use the Jimmy to lift up the black cover to get inside the device.
Step 4
Right/Left Speaker
- Desolder the two wires connected to the speaker.
Desolder the two wires connected to the speaker.
Step 5
- Use a heating gun to remove the glue from the speaker.
- Once the glue is removed, gently pull out the speaker.
Use a heating gun to remove the glue from the speaker.
Once the glue is removed, gently pull out the speaker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Katie Dunnigan
Member since: 01/24/2019
85 Reputation
1 Guide authored
Badges:
3
Team
Cal Poly, Team S1-G4, White Winter 2019
Member of Cal Poly, Team S1-G4, White Winter 2019
CPSU-WHITE-W19S1G4
4 Members
12 Guides authored
psullivan_au - Jun 14, 2019
Reply
This is awesome but Master & Dynamic don’t sell replacement 45mm 32 ohm drivers and won’t share the specs.
If anyone know where to get a replacement which will work well with these headphones please share!!!
paul
