Difficulty
Moderate
Steps
6
Time Required
15 minutes
Sections
2
- Master and Dynamic MW50 Disassembly
- 3 steps
- Charging Port
- 3 steps
Flags
0
BackMaster and Dynamic MW50
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Master and Dynamic MW50 Disassembly
- Pull the cushion off of the desired side by gripping the top of the headphones and pulling the cushion off.
Pull the cushion off of the desired side by gripping the top of the headphones and pulling the cushion off.
1024
Step 2
- Remove the four 5mm screws from the earpiece with a Y1 Triwing screwdriver.
Remove the four 5mm screws from the earpiece with a Y1 Triwing screwdriver.
Step 3
- Use the Jimmy to lift up the black cover to get inside the device.
Use the Jimmy to lift up the black cover to get inside the device.
Step 4
Charging Port
- Remove the two 2mm screws pictured with a JIS #00 screwdriver.
- Gently pull the silver cover off of the ear piece.
Remove the two 2mm screws pictured with a JIS #00 screwdriver.
Gently pull the silver cover off of the ear piece.
Step 5
- Remove the two 2mm screws shown with a JIS #00 screwdriver.
Remove the two 2mm screws shown with a JIS #00 screwdriver.
Step 6
- Lift up the mother board with the attached charging port to see the soldering points. You must desolder these points in order to detach (and re-attach) the charging port.
Lift up the mother board with the attached charging port to see the soldering points. You must desolder these points in order to detach (and re-attach) the charging port.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Tyler Guffey
Member since: 01/24/2019
208 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
Cal Poly, Team S1-G4, White Winter 2019
Member of Cal Poly, Team S1-G4, White Winter 2019
CPSU-WHITE-W19S1G4
4 Members
12 Guides authored