Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

1

  • Back Cover
  • 5 steps

Flags

0

  • BackMarvel iHome MR-M66

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Cover
  • Remove two of the three screws shown on the bottom of the device.
  • Begin removing the last screw, but leave it partially in the socket to remove the bottom cover easier.

Remove two of the three screws shown on the bottom of the device.

Begin removing the last screw, but leave it partially in the socket to remove the bottom cover easier.

1024

Step 2

  • Remove the bottom cover by either pulling on the screw or using a plastic opening tool to pry the cover off.
  • After removing the bottom cover, remove the two screws.

Remove the bottom cover by either pulling on the screw or using a plastic opening tool to pry the cover off.

After removing the bottom cover, remove the two screws.

Step 3

  • Use a spudger to release the small retaining clip that holds the feet to the bottom of the device.
  • Be careful here, as too much force can break the clip.
  • Remove the two screws from the back of the device.

Use a spudger to release the small retaining clip that holds the feet to the bottom of the device.

Be careful here, as too much force can break the clip.

Remove the two screws from the back of the device.

Step 4

  • Using a plastic opening tool and your hand, separate the front and back covers from each other.
  • Starting from the bottom, use the plastic opening tool to create the initial separation and continue along the seam to the top of the device.
  • This step requires the most time and patience, so be careful.
  • The power switch will most likely come loose during this step and you will hear something rattling inside the device.

Using a plastic opening tool and your hand, separate the front and back covers from each other.

Starting from the bottom, use the plastic opening tool to create the initial separation and continue along the seam to the top of the device.

This step requires the most time and patience, so be careful.

The power switch will most likely come loose during this step and you will hear something rattling inside the device.

Step 5

  • Remove the two arms from either side of the device once a significant separation has been created.
  • They are not fixed to the body itself so you should be able to wiggle them free.
  • Continue pulling the back cover off the device.
  • Remove the red cover for the on/off switch from the device.

Remove the two arms from either side of the device once a significant separation has been created.

They are not fixed to the body itself so you should be able to wiggle them free.

Continue pulling the back cover off the device.

Remove the red cover for the on/off switch from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Aaram Williams

Member since: 03/08/2017

201 Reputation

                                      3 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       UMass Dartmouth, Team S5-G3, Botvin Spring 2017                        

                                                  Member of UMass Dartmouth, Team S5-G3, Botvin Spring 2017 



                    UMASSD-BOTVIN-S17S5G3                     


                                            3 Members                     


                                            6 Guides authored