Difficulty

Easy

Steps

5

Time Required

                          5 - 15 minutes

Sections

1

  • Filter
  • 5 steps

Flags

3

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackWasher and Dryer

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Filter
  • Turn the machine upside down.

Turn the machine upside down.

1024

Step 2

  • Use a Phillips #0 screwdriver to remove the 3.5 mm screw holding the bottom case to the device.

Use a Phillips #0 screwdriver to remove the 3.5 mm screw holding the bottom case to the device.

Step 3

  • Cut out about 10 cm of scotch tape.
  • Turn it over and go around your hand as shown in the image, which lets the adhesive side on the outside. (Because it is easy to remove dust)
  • You can also use any other ways to remove the dust, but make sure not to break the filter.

Cut out about 10 cm of scotch tape.

Turn it over and go around your hand as shown in the image, which lets the adhesive side on the outside. (Because it is easy to remove dust)

You can also use any other ways to remove the dust, but make sure not to break the filter.

Step 4

  • Take out the filter.
  • Tap the dust and particles into the garbage, remove the dust with scotch tape, or replace the filter.

Take out the filter.

Tap the dust and particles into the garbage, remove the dust with scotch tape, or replace the filter.

Step 5

  • Check for broken/loose wiring and other connections.
  • Dust may not be the only reason for the poor performance.
  • Close the lid and replace the screw.

Check for broken/loose wiring and other connections.

Dust may not be the only reason for the poor performance.

Close the lid and replace the screw.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    [deleted]

Member since: 09/17/2021

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       2