Difficulty

Easy

Steps

9

Time Required

                          7 - 10 minutes

Sections

2

  • Battery
  • 3 steps
  • Drill Brush
  • 6 steps

Flags

0

  • BackMakita XPH01

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Hold the drill upright.
  • Place your finger on the white battery-release button.

Hold the drill upright.

Place your finger on the white battery-release button.

1024

Step 2

  • Press and hold the white release button located on the front of the battery.

Press and hold the white release button located on the front of the battery.

Step 3

  • Slide the battery forward while pressing down on the white battery-release button.

Slide the battery forward while pressing down on the white battery-release button.

Step 4

              Drill Brush
  • Hold the drill upright with the back panel facing you.

Hold the drill upright with the back panel facing you.

Step 5

  • Unscrew two 18mm screws from the back panel with the Phillips PH2 screwdriver.

Unscrew two 18mm screws from the back panel with the Phillips PH2 screwdriver.

Step 6

  • Apply slight pressure to the sides of the backplate and pull away from the drill.

Apply slight pressure to the sides of the backplate and pull away from the drill.

Step 7

  • Hold the drill so the back end is facing toward you.
  • Use the spudger to lift the spring clip out of the back notch.
  • Pull the spring clip forward and rest it in the front notch.

Hold the drill so the back end is facing toward you.

Use the spudger to lift the spring clip out of the back notch.

Pull the spring clip forward and rest it in the front notch.

Step 8

  • Use the tweezers to pull the drill brush away from the sleeve.

Use the tweezers to pull the drill brush away from the sleeve.

Step 9

  • Use the plastic opening tool to release the clip connected to the drill brush.
  • Separate the drill brush away from the clip.

Use the plastic opening tool to release the clip connected to the drill brush.

Separate the drill brush away from the clip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 5 other contributors 


                    Eric Herwatt

Member since: 10/05/2016

945 Reputation

                                      7 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 15-4, Livingston Fall 2016                        

                                                  Member of Cal Poly, Team 15-4, Livingston Fall 2016 



                    CPSU-LIVINGSTON-F16S15G4                     


                                            4 Members                     


                                            7 Guides authored

joe - Sep 13, 2019

Reply

Mehr Infos gibr’s hier » https://makita-set.bernaunet.com