Difficulty

Moderate

Steps

10

Time Required

                          10 minutes

Sections

3

  • Battery
  • 3 steps
  • Outer Casing
  • 4 steps
  • Clutch Leaf Spring
  • 3 steps

Flags

0

  • BackMakita XPH01

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Hold the drill upright.
  • Place your finger on the white battery-release button.

Hold the drill upright.

Place your finger on the white battery-release button.

1024

Step 2

  • Press and hold the white release button located on the front of the battery.

Press and hold the white release button located on the front of the battery.

Step 3

  • Slide the battery forward while pressing down on the white battery-release button.

Slide the battery forward while pressing down on the white battery-release button.

Step 4

              Outer Casing
  • Hold the drill upright with the back panel facing you.
  • Unscrew the two 18 mm screws from the back panel using a Phillips PH2 screwdriver.

Hold the drill upright with the back panel facing you.

Unscrew the two 18 mm screws from the back panel using a Phillips PH2 screwdriver.

Step 5

  • Apply slight pressure to the sides of the backplate and pull away from the drill.

Apply slight pressure to the sides of the backplate and pull away from the drill.

Step 6

  • Unscrew the nine 18 mm screws from the outer casing using a Phillips PH2 screwdriver.

Unscrew the nine 18 mm screws from the outer casing using a Phillips PH2 screwdriver.

Step 7

  • Apply slight pressure to the sides of the outer casing and pull away from the drill.

Apply slight pressure to the sides of the outer casing and pull away from the drill.

Step 8

              Clutch Leaf Spring
  • Pull the silver metal clip located towards the back of the motor assembly away from the drill.

Pull the silver metal clip located towards the back of the motor assembly away from the drill.

Step 9

  • Grip the motor comfortably towards the front of the assembly, and pull it away from the outer casing.
  • The wires are still connected to the back of the motor assembly, so use caution when pulling the motor out. Failing to do this will result in parts falling off the back of the motor.

Grip the motor comfortably towards the front of the assembly, and pull it away from the outer casing.

The wires are still connected to the back of the motor assembly, so use caution when pulling the motor out. Failing to do this will result in parts falling off the back of the motor.

Step 10

  • Slide the clutch leaf spring off with the spudger.

Slide the clutch leaf spring off with the spudger.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Eric Herwatt

Member since: 10/05/2016

945 Reputation

                                      7 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 15-4, Livingston Fall 2016                        

                                                  Member of Cal Poly, Team 15-4, Livingston Fall 2016 



                    CPSU-LIVINGSTON-F16S15G4                     


                                            4 Members                     


                                            7 Guides authored