Makita Jack Hammer Hm1307Cb Handle Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          1 - 2 minutes

Sections

Handle
3 steps

Flags

BackMakita Small Breaker HM1307CB (2011)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

As you perform this repair, take note of all the screws that have been sealed with threadlocker and be sure to clean them and reapply the same color threadlocker during reassembly.

What you need

Step 1

              Remove six screws from the handle

Remove the following screws:
Two Phillips screws
Four hex screws
These four hex screws are all held in place with threadlocker, and may take quite a bit of torque or even some heat to loosen.
During reassembly, clean the residual threadlocker from these screws, then reapply high-strength (red) threadlocker to each one before reinstalling.
If you aren’t sure how to apply threadlocker, refer to the next step in this guide.

Remove the following screws:

Two Phillips screws

Four hex screws

These four hex screws are all held in place with threadlocker, and may take quite a bit of torque or even some heat to loosen.

During reassembly, clean the residual threadlocker from these screws, then reapply high-strength (red) threadlocker to each one before reinstalling.

If you aren’t sure how to apply threadlocker, refer to the next step in this guide.

1024

Step 2

To reapply threadlocker:
First, clean the residual threadlocker from each of the screws with some cleaner/degreaser and a stiff brush.
Second, apply a couple drops of high-strength threadlocker to the screw sockets.
Finally, apply one or two drops of the same high-strength threadlocker to the tip of each screw and reinstall them.

To reapply threadlocker:

First, clean the residual threadlocker from each of the screws with some cleaner/degreaser and a stiff brush.

Second, apply a couple drops of high-strength threadlocker to the screw sockets.

Finally, apply one or two drops of the same high-strength threadlocker to the tip of each screw and reinstall them.

Step 3

              Remove the handle

Grab the handle and remove it from the jack hammer.

Grab the handle and remove it from the jack hammer.

To reassemble your device, follow these instructions in reverse order, taking note of any reassembly tips.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Taylor Dixon

Member since: 06/26/2018

62,097 Reputation

                                      94 Guides authored                  



                       Badges:
                       40







                                                        +37 more badges

Team

                       Teardown Team                        

                                                  Member of Teardown Team 



                    Community                     


                                            2 Members                     


                                            2,047 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team