Makita Jack Hammer Hm1203C 2010 Power Cord Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 - 30 minutes            

Sections

1

• Power Cord
• 8 steps

Flags

0

• BackMakita Jack Hammer HM1203C (2010)

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Remove the handle cover               

• Make sure the hammer is disconnected from power before beginning any repair.
• Use a Phillips #2 screwdriver to remove two screws securing the handle cover.

Make sure the hammer is disconnected from power before beginning any repair.

Use a Phillips #2 screwdriver to remove two screws securing the handle cover.

1024

Step 2

• Swing the bottom of the handle cover away from the hammer, then pull the cover down, toward the power cord, to remove it.

Swing the bottom of the handle cover away from the hammer, then pull the cover down, toward the power cord, to remove it.

Step 3

              Remove the power cord               

• Use a Phillips #2 screwdriver to remove the screw securing the power cord bracket.

Use a Phillips #2 screwdriver to remove the screw securing the power cord bracket.

Step 4

• Lift the bottom edge of the bracket away from the hammer slightly, then pull down to remove it.
• During reassembly, make sure the top hooked part of the bracket is inserted properly into its slot.

Lift the bottom edge of the bracket away from the hammer slightly, then pull down to remove it.

During reassembly, make sure the top hooked part of the bracket is inserted properly into its slot.

Step 5

• Use a 2.5 mm flathead screwdriver to loosen the two set screws holding in the power cord wires.

Use a 2.5 mm flathead screwdriver to loosen the two set screws holding in the power cord wires.

Step 6

• Remove the power cord.

Remove the power cord.

Step 7

• Slide the power cord guard off of the power cord.
• During reassembly, install this guard on the new power cord.

Slide the power cord guard off of the power cord.

During reassembly, install this guard on the new power cord.

Step 8

              Prepare the new power cord               

• Use 10 gauge wire strippers to strip about 1/8 inch of insulation off of each wire of the new power cord.

Use 10 gauge wire strippers to strip about 1/8 inch of insulation off of each wire of the new power cord.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Adam O'Camb                     

Member since: 04/11/2015

173,479 Reputation

                                      418 Guides authored                  



                       Badges:
                       39







                                                        +36 more badges                           

MARK - Jun 10, 2022

Reply

What does the flashing red indicator light indicate specifically? The green light is on but the red light underneath is also flashing.