Difficulty
Moderate
Steps
9
Time Required
20 - 30 minutes
Sections
2
- Back Cover
- 2 steps
- Electrical Cord
- 7 steps
Flags
0
BackMakita GA4030K
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Unscrew the 20 mm tapping screw using a Philips #02 screwdriver.
Unscrew the 20 mm tapping screw using a Philips #02 screwdriver.
1024
Step 2
- Slide the back cover down the power cable.
Slide the back cover down the power cable.
Step 3
Electrical Cord
- Place your finger in the gap in front of the switch.
- At the base of the device, push the switch lever into the ‘on’ position.
Place your finger in the gap in front of the switch.
At the base of the device, push the switch lever into the ‘on’ position.
Step 4
- Keeping the switch lever in the ‘on’ position, remove the switch.
- When reinserting the switch, place the switch in the hole without pressing the switch lever in. Holding the switch against the back edge of the hole, push the switch lever fully into the ‘on’ position and then let go. The switch should catch onto the switch lever and remain attached.
Keeping the switch lever in the ‘on’ position, remove the switch.
When reinserting the switch, place the switch in the hole without pressing the switch lever in. Holding the switch against the back edge of the hole, push the switch lever fully into the ‘on’ position and then let go. The switch should catch onto the switch lever and remain attached.
Step 5
- Pull the switch lever up and out of the body of the angle grinder.
Pull the switch lever up and out of the body of the angle grinder.
Step 6
- Pull back the plastic clip and pull the internal switch up and out of the cavity.
Pull back the plastic clip and pull the internal switch up and out of the cavity.
Step 7
- Remove the two 10 mm screws holding the power cord leads in place using a Phillips #02 screwdriver.
- When reassembling, be sure to attach the electrical cabling in the same positions.
Remove the two 10 mm screws holding the power cord leads in place using a Phillips #02 screwdriver.
When reassembling, be sure to attach the electrical cabling in the same positions.
Step 8
- Unscrew the 2 mm tapping screw using a Phillips #02 screwdriver.
- Lift the clasp up and out to remove it.
Unscrew the 2 mm tapping screw using a Phillips #02 screwdriver.
Lift the clasp up and out to remove it.
Step 9
- Remove the electrical cable.
Remove the electrical cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Laura Ann Jagels
Member since: 04/01/2015
490 Reputation
3 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 12-5, Lancaster Spring 2015
Member of Cal Poly, Team 12-5, Lancaster Spring 2015
CPSU-LANCASTER-S15S12G5
4 Members
13 Guides authored