Difficulty
Moderate
Steps
4
Time Required
20 - 30 minutes
Sections
2
- Back Cover
- 2 steps
- Carbon Brushes
- 2 steps
Flags
0
BackMakita GA4030K
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Unscrew the 20 mm tapping screw using a Philips #02 screwdriver.
Unscrew the 20 mm tapping screw using a Philips #02 screwdriver.
1024
Step 2
- Slide the back cover down the power cable.
Slide the back cover down the power cable.
Step 3
Carbon Brushes
- Use a spudger to move the springs (holding the brushes) to the side.
- There are two brushes, one on each side.
Use a spudger to move the springs (holding the brushes) to the side.
There are two brushes, one on each side.
Step 4
- Use needle nose pliers to gently pull out the carbon brushes by their crimped connectors.
Use needle nose pliers to gently pull out the carbon brushes by their crimped connectors.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 3 other contributors
Nyssa Backes
Member since: 04/01/2015
455 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 12-5, Lancaster Spring 2015
Member of Cal Poly, Team 12-5, Lancaster Spring 2015
CPSU-LANCASTER-S15S12G5
4 Members
13 Guides authored