Difficulty

Moderate

Steps

11

Time Required

                          10 minutes

Sections

2

  • Battery
  • 3 steps
  • Trigger Switch
  • 8 steps

Flags

0

  • BackMakita DT01 Impact Driver

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Lay the device down on its side.

Lay the device down on its side.

1024

Step 2

  • Pinch the indents on both sides of the battery.

Pinch the indents on both sides of the battery.

Step 3

  • Pull the battery out of the drill
  • Recharge or completely replace the battery
  • Make sure that the battery is removed before further working on the drill. This is so the drill doesn’t accidentally activate.

Pull the battery out of the drill

Recharge or completely replace the battery

Make sure that the battery is removed before further working on the drill. This is so the drill doesn’t accidentally activate.

Step 4

              Trigger Switch
  • Unscrew all six 15mm screws with a JIS1 screwdriver bit.

Unscrew all six 15mm screws with a JIS1 screwdriver bit.

Step 5

  • Remove the top of the plastic drill case

Remove the top of the plastic drill case

Step 6

  • Remove the bottom of the plastic drill case

Remove the bottom of the plastic drill case

Step 7

  • Use your tweezers to remove the black wire from the motor

Use your tweezers to remove the black wire from the motor

Step 8

  • Use your tweezers to remove the red wire from the motor

Use your tweezers to remove the red wire from the motor

Step 9

  • Your trigger switch should now be removed from your motor

Your trigger switch should now be removed from your motor

Step 10

  • Use your tweezers to remove the red and black wires from the two-pronged plug

Use your tweezers to remove the red and black wires from the two-pronged plug

Step 11

  • Your trigger switch is now detached from the device

Your trigger switch is now detached from the device

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Victoria Scira

Member since: 02/15/2017

226 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges