Difficulty

Moderate

Steps

4

Time Required

                          15 - 20 minutes

Sections

1

  • Motor
  • 4 steps

Flags

0

  • BackMakita DT01 Impact Driver

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motor
  • Place your fingers on the grip to pull out the battery from the device.

Place your fingers on the grip to pull out the battery from the device.

1024

Step 2

  • Unscrew the device using the driver from the JIS kit.
  • Use the part J1 as the Screw diver tip.
  • There are 6 screws and each have a 15 mm Phillips-head.

Unscrew the device using the driver from the JIS kit.

Use the part J1 as the Screw diver tip.

There are 6 screws and each have a 15 mm Phillips-head.

Step 3

  • Pull both ends of the device to separate the motor from the rest of the device.

Pull both ends of the device to separate the motor from the rest of the device.

Step 4

  • Use the tweezer to disconnect both the wires connected to the motor.

Use the tweezer to disconnect both the wires connected to the motor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Haseeb Ur Rehman

Member since: 04/21/2017

109 Reputation

                                      1 Guide authored                  



                       Badges:
                       1