Difficulty
Moderate
Steps
3
Time Required
4 minutes
Sections
1
- LED light
- 3 steps
Flags
Confusing Text
Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!
Needs Better Images
Better photos will improve this guide. Help out by taking, editing, or uploading new ones!
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackMakita DT01 Impact Driver
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
LED light
- Take out the battery.
- Unscrew the six screws in the top of the drill.
Take out the battery.
Unscrew the six screws in the top of the drill.
1024
Step 2
- Motor and trigger should be separated.
- The LED cable should be taken out from the trigger.
Motor and trigger should be separated.
The LED cable should be taken out from the trigger.
Step 3
- Take out the plastic tape that is stacked on the LED light.
- Take out the two cables that are connecting with the LED light.
- Reconnect the two cables again with the new LED light.
Take out the plastic tape that is stacked on the LED light.
Take out the two cables that are connecting with the LED light.
Reconnect the two cables again with the new LED light.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Ya'Rub Al Manwari
Member since: 02/15/2017
201 Reputation
2 Guides authored
Badges:
2