Difficulty
Very difficult
Steps
5
Time Required
Suggest a time??
Sections
1
- Truck Circuit Board
- 5 steps
Flags
0
BackMaisto Rock Crawler
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Truck Circuit Board
- Flip the R/C truck over.
- To take off the R/C truck top, use the driver and bit PH2 and remove the four 7.7mm Philips screws highlighted.
Flip the R/C truck over.
To take off the R/C truck top, use the driver and bit PH2 and remove the four 7.7mm Philips screws highlighted.
1024
Step 2
- Half way remove the truck top so you can unhinge the antenna from the clips.
- Remove the R/C truck top completely.
Half way remove the truck top so you can unhinge the antenna from the clips.
Remove the R/C truck top completely.
Step 3
- Use the Driver and bit J1 to remove the top under-body plate by unscrewing the eight 9.5mm Philips screws.
Use the Driver and bit J1 to remove the top under-body plate by unscrewing the eight 9.5mm Philips screws.
Step 4
- Use the driver and bit J1 and remove the 7.7mm Philips screw highlighted.
Use the driver and bit J1 and remove the 7.7mm Philips screw highlighted.
Step 5
- Take note of which wire is connected at which pin before desoldering. It might help to mark the wires and take a picture.
- It would be easier to desolder and resolder only one component at a time.
- Use the soldering iron to desolder all the wires connected to the circuit board.
Take note of which wire is connected at which pin before desoldering. It might help to mark the wires and take a picture.
It would be easier to desolder and resolder only one component at a time.
Use the soldering iron to desolder all the wires connected to the circuit board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 3 other contributors
kevin
Member since: 02/10/2016
874 Reputation
6 Guides authored
Badges:
9
+6 more badges
Team
USF Tampa, Team 1-2, Sullivan Spring 2016
Member of USF Tampa, Team 1-2, Sullivan Spring 2016
USFT-SULLIVAN-S16S1G2
3 Members
6 Guides authored
Matt John - Jan 21, 2017
Reply
Can you do anything to it to make it stronger are powerful
Mike - Feb 3, 2017
Reply
Yes put a board from a nikko or ez tec in it. The 9.6 volt is the one to find and wire the motors to the single motor output. I think u have to wire one backwards to get both going right way
pankaj kapatia - Jan 7, 2018
Reply
My rc car is not responding to left or right signals from remote.
CAN I got any help on this
Can any one help as my rc rock crawler is not turning left or right
mattilajanne - May 9, 2018
Reply
did you use biger voltage than normal? because it sound like that. i think your’s car has brokened ic-component.