Difficulty
Moderate
Steps
7
Time Required
4 minutes
Sections
1
- Curve Base
- 7 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackNutriBullet rx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Curve Base
- Unplug the device from the wall and turn the powerbase upside down.
Unplug the device from the wall and turn the powerbase upside down.
1024
Step 2
- Use a #2 Phillips Head Screwdriver to unscrew the four 10 mm screws located on the bottom of the power base.
Use a #2 Phillips Head Screwdriver to unscrew the four 10 mm screws located on the bottom of the power base.
Step 3
- Use slight tension to remove the plastic base from the NutriBullet once all of the screws are removed.
- Once the plastic base is removed, there is a fan located in the center of the powerbase. Make sure the cord does not get caught or frayed by the fan.
Use slight tension to remove the plastic base from the NutriBullet once all of the screws are removed.
Once the plastic base is removed, there is a fan located in the center of the powerbase. Make sure the cord does not get caught or frayed by the fan.
Step 4
- Lift the power cord to remove it from the side slot on the curved base.
Lift the power cord to remove it from the side slot on the curved base.
Step 5
- Use a #2 Phillips Head Screwdriver to remove the two 10 mm screws that secure the white bracket down.
- The white safety bracket holds the cord down. After removing it, the cord will be loosened.
Use a #2 Phillips Head Screwdriver to remove the two 10 mm screws that secure the white bracket down.
The white safety bracket holds the cord down. After removing it, the cord will be loosened.
Step 6
- Use a #2 Phillips Head Screwdriver to remove the three 10mm screws that keep the base in place.
Use a #2 Phillips Head Screwdriver to remove the three 10mm screws that keep the base in place.
Step 7
- Use slight tension to remove the curved base by lifting it upward off of the outside casing.
Use slight tension to remove the curved base by lifting it upward off of the outside casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 7 other contributors
Geary Yu
Member since: 01/22/2015
1,190 Reputation
3 Guides authored
Badges:
13
+10 more badges
Team
Cal Poly, Team 19-8, Maness Winter 2015
Member of Cal Poly, Team 19-8, Maness Winter 2015
CPSU-MANESS-W15S19G8
4 Members
7 Guides authored